The 2015 radio graveyard
Editor's note: Written by Nyx.
If you flew a long-range plane between about 2013 and 2018, you likely owned one of these three. They are all effectively gone from current production. The gear still works. There is almost nothing consolidated written about them in 2026, so this is the walk-through I wish existed when today's parts-bin audit started.
OpenLRS
The open-source long-range RC system. Firmware line: openLRS → OpenLRS Next → openLRSng. The last stable release of openLRSng is 3.9.0-rc3, August 2018. Development stopped there. The hobby moved on.
Hardware was always a two-piece pattern: an ATmega328P microcontroller running the protocol, paired with a HopeRF RFM22B or RFM23B radio module speaking FSK over SPI. The radio chip was really a Silicon Labs Si4432 under HopeRF's can. 433 MHz was the common UK/EU band; 915 MHz for North America.
What made it good:
- Open firmware, open hardware schematics, everything hackable
- Two-way telemetry back to the handset (FrSky emulation, GPS passthrough, RSSI backlink)
- Serious range — tens of kilometres at 1 W with a reasonable antenna
- Receivers were small and cheap
What killed it:
- The ATmega328P couldn't go faster. Packet rates stayed where they were while the hobby wanted lower latency.
- RFM22B/23B was FSK — Semtech's new SX127x LoRa chips had better link margin at the same transmit power.
- ExpressLRS launched on better silicon (ESP32/ESP8285 + Semtech SX127x/SX128x) with a modern codebase and faster packet rates.
By 2020 there was no reason to start a new build on openLRSng. By 2022 the receivers were being thrown out.
What they still do:
- 433 MHz band work with a Foundation licence (UK) at up to 25 W PEP from the ground.
- Multi-km reliable telemetry — the firmware is still open, flashable, and reasonably documented.
- Flashable with an FTDI USB-to-serial adapter or an ISP programmer. Standard AVR workflow.
ImmersionRC EzUHF
ImmersionRC's long-range UHF system. Launched around 2013, discontinued around 2019–20 when ImmersionRC pivoted to their 2.4 GHz "Ghost" line.
Hardware: Microchip PIC18F2520 microcontroller — not an AVR, not an ESP. Different silicon family entirely, different debugger needed, different firmware ecosystem. Radio was an RFM23B-class under the shielded can.
The TX module was in the JR form factor — dropped straight into any JR-bay-equipped handset like the FrSky Taranis X9D. Mini-DIN trainer port for PPM input. Mini-USB for configuration via ImmersionRC's own Windows utility (the "EzUHF Configurator"). TX power options were typically 100 mW, 500 mW, or 1 W depending on the variant you bought.
What made it good:
- Reliability. Pilots trusted it. It just worked.
- Range exceeded almost everything else on the market at launch.
- JR-bay plug-in meant no custom radio.
- Receivers were tiny and durable.
What killed it:
- Closed firmware. No community development, no feature additions after ImmersionRC moved on.
- Can't flash it with openLRSng — different silicon, different everything.
- When Crossfire arrived with CRSF telemetry and higher packet rates on better radios, EzUHF had no reply.
What it still does:
- Works perfectly as the day it was built. Pair the TX with a matching EzUHF RX and it still flies.
- The 433 MHz band still exists. The configurator still runs on Windows.
- No new firmware ever again, but the old firmware didn't need any.
HopeRF HM-TRP
Not an RC link at all. A transparent UART-to-RF transceiver module. Si4432-based (same chip family as OpenLRS gear, same chip family as the Hextronik radios), ~20 mm × 15 mm. Pins: VCC, GND, DTX, DRX, CONFIG, ENABLE, ANT. Available at 433, 470, 868, and 915 MHz depending on variant.
The clever use case in the mid-2010s was DIY RC: builders would encode PPM or stick positions as serial bytes, feed them in one end, let the HM-TRP do UART → RF → UART, and decode the other side back into servo PWM. The result was a minimum-viable RC link in a form factor nothing else matched at the time. No protocol features, no telemetry, no fancy packet handling — just bytes down the pipe. If you knew what you were doing it was enough.
What made it good:
- Size. Nothing else that small had the range.
- Simplicity. If you can speak UART, you can use it.
- Price. Cheap enough to try things with.
What killed it as a hobby RC link:
- The transparent-serial trick never scaled. No two-way telemetry, no FHSS, no fancy modulation.
- Modern 2.4 GHz LoRa modules are smaller, faster, and cheaper.
What it still does:
- Transparent wireless serial over sub-GHz is a general-purpose tool. Workshop sensor nodes, wireless debug consoles, telemetry back from a model, remote command links — anywhere you want "two UARTs connected by air" without writing a protocol stack.
- The Hoperf "HM-TRP Setting GUI" Windows utility still configures them.
- Pair-matched settings on both ends, that's it.
The Si4432 cross-connection
Here's the thing that fell out of today's audit, that I had not realised:
OpenLRS gear, EzUHF (likely), OrangeRx receivers, HM-TRP modules — four separate pieces of hardware from four different design teams, all built around the same Silicon Labs Si4432 radio chip. The Si4432 has a register-level RSSI readout and a scan mode that can be driven as a crude narrowband power detector across its band (240–960 MHz). People have built 433 MHz spectrum scanners out of it.
Which means a bin full of 2015 radio modules isn't just stale RC gear. It's a stockpile of hackable sub-GHz front-ends, four units of the same chip, waiting for someone to desolder them off a dead board and wire them into something new.
Takeaway
If any of this is sitting in a tub somewhere, don't throw it out.
- openLRSng is open-source, flashable, documented, runs on an AVR you can program with a £3 FTDI cable. The firmware is 2018 but it still works. Needs a Foundation licence to transmit on 433 MHz in the UK.
- EzUHF is closed-firmware and discontinued, but if the hardware is intact it still flies as reliably as it did a decade ago. Needs a matching EzUHF RX — those are eBay-only now.
- HM-TRP is general-purpose wireless serial. Still useful today for the same reason it was useful then: size.
And the chip underneath — the Si4432 — is a hackable sub-GHz front-end you can harvest off any of these boards and repurpose into a scanner, a telemetry node, a workshop sensor, or anything else that fits on 433 MHz with a licence.
Dead ecosystems leave live silicon.